UL 61800-5-1 Listed: Tested to the latest UL standard
MM Footprint: Industry standard mounting pattern developed by ACE
Compact Size: Smaller footprint than other MM mounting pattern controls to use minimal space
Microprocessor Based: Allows custom programming for OEMs
Variety of Motors: Permanent Split Capacitor (PSC), Shaded Pole, Synchronous, and 3Ø Induction
Doubler Mode: Will run 230 VAC motors with a 115 VAC line
Torque Foldback: Allows up to 200% torque for short periods to overcome intermittent peak loads, then reduces the torque to a (preset) safe level
Isolated Logic: Accepts floating or grounded 0-5 VDC, 0-10 VDC, 4-20 mA, or 24V 1kHz PWM signals
Selectable Auto/Manual Restart: Use a jumper to select if the drive should automatically restart after a fault condition clears
Adjustable Base Frequency: Can be set for 50 or 60 Hz at rated output voltage, regardless of input frequency
Selectable Switching Frequency: 12kHz for audibly quieter motor operation, 2kHz for less electrical noise and may prevent GFI tripping.
DC Injection Braking: Can be used for quicker braking
Thermally Protects: Drive recognizes when overheated as a result from overload. After flashing a warning code, it will trip if condition persists
Diagnostic LEDs: Power, Status (Torque Limit, Undervoltage, Overvoltage, Short Circuit, Overheat Warning, Overheat Trip)
User Adjustable Calibration Trim Pots: Minimum Speed, Maximum Speed, Torque Limit, Slip Compensation, Boost, Acceleration/Deceleration, Motor Overload Protection
Modus Communication: Modbus RTU over RS485
