MUN100-10 DC Motor Control

MUN Series

The MUN series is American Control Electronics approach to competition...by adding value. We've taken the LGC400-10 and kept the most commonly requested features; 115 VAC input for a 90 VDC permanent magnet motor. We've compressed the physical footprint of the drive to save space for customers who are mounting these units into panels. However, we kept the classic industry standard footprint that American Control Electronics created and is known for. Furthermore, we've added a microprocessor which allows us to either run custom routines or we can set the trim pot parameters internally, allowing us to remove the trim pots for cost savings and optimizing customer setup time and field installation.

Potentiometer Kit 202-0031 is included with a purchase of the MUN100-10

$229.93

Qty:

Contact the factory for volume pricing

Model Number	Enclosure	Maximum Current (ADC)	Input Voltage (VAC)	Output Voltage (VDC)	Power Range		Field / Shunt Supply	Braking	Reversing	Isolation
					HP	kW
MUN100-10	Chassis	10*	115	0 - 90	1/20 - 1	.04 - .75	No	No	No	No

* Heat sink kit 223-0159 must be used when the continuous output current is above 5 amps.

Features

Low Cost: Designed for cost savings in large quantities for OEMs
Microprocessor Based: Allows custom programming for OEMs
ACE Footprint and Compact Size: Traditional ACE mounting pattern with smaller footprint uses minimal space
Stopping Modes: Inhibit (N.O.) for coasting to a stop. Can be used for frequent starting and stopping

Technical Data

1.37 Form Factor
1% Base Speed Regulation
60:1 Speed Range

Trim Pots

Maximum Speed
Minimum Speed
Acceleration
Deceleration
Current Limit
IR Compensation

Quick Start Guide

2D .DXF File

3D .IGS & .STEP Files