LGM103-10 DC Motor Control

LGM Series

With the LGM series, the features list just keeps growing. With its Burr Brown linear isolated input, the LGM series can accept a grounded 4-20 mA or 0-10 VDC signal from any Programmable Logic Control (PLC) or motion card to control motor speed. With its isolated inputs, the LGM series can easily be enabled or inhibited using NPN open collector transistors, dry contact relays, or switches. Status LEDs on the drive also allow for convenient monitoring. With separate models designed to accept either 115 or 230 VAC power and all the standard features offered by our 1Q drive family, this series can effortlessly be incorporated into any demanding application where electrical isolation is needed.

Potentiometer Kit 202-0079 is included with a purchase of the LGM103-10

$414.44

Qty:

Contact the factory for volume pricing

Model Number	Enclosure	Maximum Current (ADC)	Input Voltage (VAC)	Output Voltage (VDC)	Power Range		Field / Shunt Supply	Braking	Reversing	Isolation
					HP	kW
LGM103-10	Chassis	10*	115	0 - 90	1/8 - 1	.09 - .75	50 / 100	No	No	0 - 10 VDC 4 - 20 mA

* Heat sink kit 223-0159 must be used when the continuous output current is above 5 amps.

Features

ACE Footprint: Traditional ACE mounting pattern and footprint
Isolated Logic: Allows floating or grounded 0 - 10 VDC signal
Field Supply: Voltage output to energize the field winding of a shunt-wound motor
Stopping Modes: Inhibit (N.O. or N.C.) for coasting to a stop. Can be used for frequent starting and stopping
Diagnostic LEDs: Current Limit, Inhibit, Power, Run
On-board Fuses: Drive includes an on-board fuse

Technical Data

1.37 Form Factor
2% Base Speed Regulation
60:1 Speed Range

Trim Pots

Maximum Speed
Minimum Speed
Acceleration
Deceleration
Current Limit
IR Compensation