click here to chat with us
DCR600-60 Low Voltage Motor Control

DCR600-60 Low Voltage Motor Control

DCRx00-60 Series

The DCR600-60 is a microprocessor based, low voltage PWM drive for brushed DC motors up to 48 VDC, rated for 30 amps continuous operation or 60 amps for one minute. They are regenerative controls capable of braking or reversing on-the-fly without the use of braking resistors or motor lead swapping. The drives are equipped with a brake output that can be used to power electro-mechanical brake or an external run status LED. There are two on-board LEDs that are used to communicate run status and fault conditions, while jumpers are used to select between Speed or Torque mode operation as well as unidirectional or bidirectional control with a 0 – 5 VDC analog signal. Protective circuitry helps shield the drive from shorts on the armature output and a pre-charge circuit limits in-rush current to protect the power contacts. The microprocessor allows for custom programming to fit various OEMs custom needs, potentially eliminating the need for a PLC and supporting devices. As an example, drives can be programmed for use in the field without trim pots, saving the customer time and money on installation, calibration, and field support.

Potentiometer Kit 202-0182 is included with a purchase of the DCR600-60


Contact the factory for volume pricing

Enclosure Maximum
Power Range
Continuous (Peak)
Braking Reversing Isolation
DCR600-60 Chassis 30 60 36 0 - 36 1/12 - 2/3 (1 1/3) .07 - .50 (.99) Yes
48 0 - 36 1/12 - 2/3 (1 1/3) .07 - .50 (.99)
0 - 48 1/6 - 1 1/3 (2 2/3) .15 - 1.0 (1.8)

* Peak time of 1 minute.


  • Microprocessor Based: Allows custom programming for OEMs
  • Ideal for Battery Powered Equipment: Maintains both set and/or variable speed even as battery voltage declines. Extends total running time of equipment
  • 4Q Reversing: Regenerative / 4-Quadrant drives have the ability to perform quick and contactorless braking and/or reversing-on-the-fly
  • Coil Output: Applies a voltage out to a brake coil when the drive is disabled or stopped
  • Stopping Modes: N.C. enable coasts to a stop. N.O. inhibit brakes to a stop. Can be used for rapid starting and stopping
  • High Efficiency: Outputs up to 100% of the input voltage
  • Diagnostic LEDs: Power, Status (Current Limit, Undervoltage, Overvoltage, Overheat Foldback)
  • Precharge Circuit: Prevents large current in-rushes on power up to extend the life of power contacts

Technical Data

  • 1.01 Form Factor
  • 1% Base Speed Regulation
  • 100:01 Speed Range

Trim Pots

  • Forward Maximum Speed
  • Reverse Maximum Speed
  • Minimum Speed
  • Acceleration
  • Deceleration
  • Motor Current Limit
  • Regen Current Limit
  • IR Compensation