DCR300-30 Low Voltage Motor Control

DCR Series

The DCR series are microprocessor based, low voltage PWM drives that are capable of braking and reversing regeneratively. The microprocessor allows for custom programming to fit any OEMs custom needs, sometimes eliminating the need for a PLC and/or sensors. They can even be programmed for use in the field without trimmer potentiometers, creating a simple install and a level of security for OEMs. Some models contain a “sleep mode” which extends battery life, and some contain a Fault LED with a built in flashing code for under voltage, over voltage, current limit, overheat, and short circuit. With features like pre-charge circuits, brake outputs, directionally based inhibits, you’re sure to find a drive to fit your needs. See the DCR series in action here.

Check out the DCR300-30-CYC drive.

Potentiometer Kit 202-0125 is included with a purchase of the DCR300-30

Success Story

Let's Talk About Your Project

$410.03

Qty:

Contact the factory for volume pricing

Model Number	Enclosure	Maximum Current (ADC)	Peak Current (ADC)*	Input Voltage (VDC)	Output Voltage (VDC)	Power Range Continuous (Peak)		Braking	Reversing	Isolation
						HP	kW
DCR300-30	Chassis	15	30	12	0 - 12	1/50 - 1/6 (3/8)	.015 - .12 (.28)	Yes (Regenerative)	Yes (Regenerative)	No
				24	0 - 12	1/50 - 1/6 (3/8)	.015 - .12 (.28)
					0 - 24	1/25 - 1/3 (3/4)	.03 - .25 (.56)

* Peak time of 1 minute.

Features

Microprocessor Based: Allows custom programming for OEMs
Ideal for Battery Powered Equipment: Maintains both set and / or variable speed even as battery voltage declines. Extends total running time of equipment
4Q Reversing: Regenerative / 4-Quadrant drives have the ability to perform quick and contactorless braking and/or reversing-on-the-fly
Coil Output: Applies a voltage out to a brake coil when the drive is disabled or stopped
Stopping Modes: N.C. forward and reverse inhibits brake to a stop. Can be used for rapid starting and stopping
High Efficiency: Outputs up to 95% of the input voltage
Diagnostic LEDs: Power, Status(Current Limit, Undervoltage, Overvoltage, Overheat Foldback)