DCL300-30 Brushless Motor Control

DCL Series

The DCL series is a low voltage, brushless motor controller that operates in the 12-48 VDC power bandwidth, up to 30 amps peak (1 minute) or 15 amps continuously. The drive is a unique approach to motion control as the base DCL unit is designed for cost conscience OEMs. By removing many of the trim pots and jumpers associated with motor controls, the DCL saves cost on hardware and setup, but can be programmed by American Control Electronics for your specific application and motor.

For brushless motor control users who wish to modify calibration in the field, the DCL uses programmer board CPC300-1 (sold separately) that snaps onto the unit and provides calibration of 10 different parameters, as well as DIP switches for setting different modes of operation. You only need one CPC300-1 as the adder board can be removed after programming and used with multiple DCL units.

Base DCL units are Modbus capable and come with one trim pot for calibrating maximum speed, and two DIP switches for closed / open loop operation, as well as inverting the hall effect feedback.

Potentiometer Kit 202-0176 is included with a purchase of the DCL300-30

Let's Talk About Your Project

$264.44

Qty:

Contact the factory for volume pricing

Model Number	Enclosure	Maximum Current (ADC)	Peak Current (ADC)*	Input Voltage (VDC)	Output Voltage (VDC)	Power Range Continuous (Peak)		Braking	Reversing	Isolation	Feedback
						HP	kW
DCL300-30	Chassis	15	30	12	0 - 12	1/50 - 1/6 (3/8)	.01 - .12 (.28)	Yes	Yes	No	Hall Effect Sensors
				24	0 - 24	1/25 - 1/3 (3/4)	.03 - .25 (.56)

* Peak time of 1 minute.

Features

ACE Footprint: Traditional ACE mounting pattern and footprint
Field Supply: Voltage output to energize the field winding of a shunt-wound motor
Stopping Modes: Inhibit (N.O.) for coasting to a stop. Can be used for frequent starting and stopping
Diagnostic LEDs: Current Limit