PML Series

Model
Number
Enclosure Maximum
Current
(ADC)
Input
Voltage
(VAC)
Output
Voltage
(VDC)
Power Range Braking
&
Reversing
Isolation Feedback
HP kW
PML703-3 Chassis 3.6* 115 0 - 140 1/20 - 1/2 .04 - .37 Yes
(Regenerative)
0±5, 0±10 VDC
4-20 mA
Hall Effect Sensor
0 - 240 1/10 - 1 .07 - .75
230 0 - 180 1/20 - 1/2 .04 - .37
0 - 240 1/10 - 1 .07 - .75
PML703-5 Chassis 5.0** 115 0 - 140 1/15 - 1 .05 - .75 Yes
(Regenerative)
0±5, 0±10 VDC
4-20 mA
Hall Effect Sensor
0 - 280 1/8 - 2 .09 - 1.5
230 0 - 140 1/15 - 1 .05 - .75
0 - 280 1/8 - 2 .09 - 1.5
* When mounted parallel with wall / perpendicular to ground. De-rate to 3.0 amps when mounted in any other configuration.
** When mounted to allow upwards air flow through the heat sink fins. De-rate to 4.0 amps when mounted in any other configuration.

The PML series is a general purpose drive for a wide variety of trapezoidal-wound brushless motors. With either a 115 VAC or 230 VAC line source, our drive can control motors that vary in the 90 to 280 VDC range, up to 5 amps or 1.5 HP. With the use of on-board trim pots, you can quickly set the maximum and minimum speeds, acceleration and deceleration rates, motoring and regening current limits, and the proportional and integral feedback gains. Each drive is designed for feedback from 120° hall effect sensors, and can be commanded with a wide range of analog inputs with our built-in isolation. The drive is a 4Q PWM controller, allowing the unit to be used as a unidirectional or bidirectional controller. The microprocessor based design means it can be modified to fit OEM specific applications.